Teldat bintec RT1202 Uživatelský manuál stáhnout pdf (Strana 209)

100

101

Field Description

6,3, (:* .", 6,3 and (:* ?<",

6,3.

Mode Select when the interface defined in Route Parameters->Inter-

face is to be used.

Possible values:

• .,3)  1 (default value): The route can be used if

the interface is "up". If the interface is "dormant", then dial and

wait until the interface is "up".

• -3: The route can always be used.

• .,3)  "3: The route can be used when the

interface is "up". If the interface is "dormant", then select and

use the alternative route (rerouting) until the interface is "up".

• ' ,3): The route can be used when the interface is

"up".

• -,1&# ,3): The route can be used when the interface

is "up". If the interface is "dormant", then dial and wait until the

interface is "up". In this case, an alternative interface with a

poorer metric is used for routing until the interface is "up".

14.1.2 IPv4 Routing Table

A list of all IPv4 routes is displayed in the Network->Routes+IPv4 Routing Table menu.

The routes do not all need to be active, but can be activated at any time by relevant data

traffic.

Fig. 79: Network->Routes+IPv4 Routing Table

Fields in the menu IPv4 Routing Table

Teldat GmbH

14 Networking

bintec Rxxx2/RTxxx2 195

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 621 622

Komentáře k této Příručce

Žádné komentáře

Teldat bintec RT1202 Uživatelský manuál Strana 209

Komentáře k této Příručce