Teldat bintec RT1202 Uživatelský manuál stáhnout pdf (Strana 294)

100

101

Field Description

defined as the default route.

The function is enabled with ,.

The function is enabled by default.

Create NAT Policy Specify whether Network Address Translation (NAT) is to be ac-

tivated.

The function is enabled with ,.

The function is enabled by default.

Local IP Address Only for IP Address Mode = *"

Assign an IP address from your LAN to the PPT interface, which

is to be used as your device's internal source address.

Route Entries Only if IP Address Mode = *"

Define other routing entries for this PPTP partner.

Add new entries with Add.

• @  -##: IP address of the destination host or

network.

• '#7: Netmask for Remote IP Address If no entry is

made, your device uses a default netmask.

• %": The lower the value, the higher the priority of the

route (range of values ... ). The default value is .

The menu Advanced Settings consists of the following fields:

Fields in the Advanced Settings menu.

Field Description

Block after connection

failure for

Enter the wait time in seconds before the device should try

again after an attempt to set up a connection has failed. The de-

fault value is .

Maximum Number of

Dialup Retries

Enter the number of unsuccessful attempts to setup a connec-

tion before the interface is blocked.

Possible values are  to .

17 WAN Teldat GmbH

280 bintec Rxxx2/RTxxx2

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 621 622

Komentáře k této Příručce

Žádné komentáře

Teldat bintec RT1202 Uživatelský manuál Strana 294

Komentáře k této Příručce